![]() This is required because network changes are not dynamically propagated to the Avid DS Indexing Services. Important: Every time that you change from an active network connection into the Loopback Adapter mode and back, run Configure DS Workgroup and select the "Change logon information" option. If you later connect the Avid DS workstation to a network and you enable the network adapter, make sure that you disable the Microsoft Loopback Adapter to avoid networking conflicts, mainly with the Avid Project Indexer. We also suggest that you rename the adapter to make its identification easier. The exclamation point warning will disappear from the network icon. Manually set a bogus 100.100.100.1 IP address to avoid potential Avid DS indexing services errors.Ī public IP address can also be used if your IT department request that instead. What if the Loopback displays an exclamation point as in this example? * 127.0.0.1 must appear as the valid IP as this is the loopback address. ![]() The result should display a few lines similar to these:.In a Command Prompt window, type PING "computer name" ( the name of the workstation).It is also recommended to disconnect the network cable if present. The Local Area Connection icon will turn gray and the Status will display Disabled. Right click on Local Area Connection and select Disable. To be able to use the Microsoft Loopback Adapter for an Avid DS workstation, you must disable the Local Area Connection for the network adapter. In the "Hardware to install:" dialog, you see "Microsoft Loopback Adapter".In the "Manufacturer" list, select "Microsoft", then in the "Network Adapter:" list select "Microsoft Loopback Adapter", and then click Next.Browse the "Common hardware types:" list, select "Network adapters" and click Next.When asked "What do you want the wizard to do?", select "Install the hardware that I manually select from a list (advanced)", and click Next.Browse the "Installed Hardware:" list to the bottom, select "Add a new hardware device" and click Next.To the "Have you already connected this hardware to your computer?" question, select "Yes, I have already connected the hardware", and click Next.From the Start menu, select Control Panel ( or under Settings with Windows Classic mode). ![]() Windows XP Professional (x86) and 圆4 Edition instructions:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |